HRX-OM-X037
Chapter 7 Alarm Notifications and Troubleshooting
HRL Series 7.1 Alarm Notification
Chapter 7 Alarm Notifications and
Troubleshooting
7.1 Alarm Notification
The product makes notifications in the order shown below when any alarm is
generated.
The screen automatically moves to the "Information" screen and
displays alarm codes and alarm contents.
(Refer to "5.4.4 Information screen" for the operation method of
"Information" screen.)
Contact signal of the contact input/output communication is output.
It is possible to read the alarm status using serial communication.
Refer to the Operation Manual Communication Function for more
details.
7.2 Operation of this product when an alarm occurs
When an alarm occurs, this product operates in two ways depending on the
content of the alarm.
Operation continuation alarm : When an alarm occurs, this product
continues to operate. The alarm content will display "WRN".
Operation stop alarm : When an alarm occurs, this product stops.
The alarm content will display "FLT".
There is an alarm content that allows you to select the action when an
alarm occurs. There are also alarm contents that can disable (turn off) the
alarm function. Refer to "Table 7.3-1 and 7.3-2 Alarm codes and
troubleshooting”.
Alarm codes
&
Alarm contents
To Next Page
Loading...
Need help?
General
