HRX-OM-X037
Chapter 5 Display and Setting of Various Functions
HRL Series 5.4 Description of the Screen
・RUN/STOP display
11. Indicates whether the product is running or has stopped running.
・Run/stop operation
12. Run/Stop the product. Press [ ] button when the product has stopped running to
display “Operation check screen”. Press [ ] button to start operation.
The “Operating condition display” described in 11 flashes to indicate the period before
operation starts (operation preparation period).
Press [ ] button when the product is running to display “Stop check screen”.
Press [ ] button to stop the operation. “Operating condition display” described
in 11 flashes during the period before the operations stops (stop preparation period)
[Tips]
• If [ ] button is pressed when “Run/Stop (FLT)” alarm is activated,
the “Cannot Run” message appears.
Please turn off the alarm. Refer to “Chapter 7 Alarm Notifications and
Troubleshooting” for turning off the alarm.
• If the “Operation mode” is set to anything other than “LOCAL”, a “Switch to
the local mode” message appears. Set the running mode to the “LOCAL”
mode.
Cannot run because of the fault alarm
To Next Page
Loading...
Need help?
General
