LI-32
LIGHTING SYSTEM
Glove Box Light
28.Glove Box Light
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the glove box. <Ref. to EI-37, REMOV-
AL, Glove Box.>
3) Disconnect the harness connector.
4) Remove the glove box light.
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2, SPEC-
IFICATION, General Description.>
3) If NG, replace the bulb with a new one.
LI-00044
To Next Page
Loading...
