GW-24
GLASS/WINDOW/MIRROR
Rear Regulator and Motor Assembly
12.Rear Regulator and Motor As-
sembly
A: REMOVAL
1) Remove the door glass. <Ref. to GW-22, RE-
MOVAL, Rear Door Glass.>
2) Remove the front sash.
3) Disconnect the motor connector.
4) Loosen the four bolts and two nuts to remove
regulator assembly.
5) Loosen the screws to remove motor assembly.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Adjust the rear door glass. <Ref. to GW-23, AD-
JUSTMENT, Rear Door Glass.>
Tightening torque:
Refer to COMPONENT in General Descrip-
tion. <Ref. to GW-4, REAR DOOR GLASS,
COMPONENT, General Description.>
C: INSPECTION
1) Make sure that the power window motor rotates
properly when battery voltage is applied to the ter-
minals of motor connector.
2) Change polarity of battery connections to the ter-
minals to ensure that the motor rotates in reverse
direction.
GW-00035
GW-00036
To Next Page
Loading...
