Supermicro SSE-F3548S - Page 101

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
101
protocol fields in hex format as aa:aa.
Second: frame type as enet-v2, llc or
snap.
Third: protocol group identifier
number.
Step 6
interface <interface-type> <interface-id>
or
interface range <interface-type> <interface-id>
….
Enters the interface mode.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
port-channel – po
interface-id is in slot/port format for all
physical interfaces. It could be the port
channel identifier for port channel
interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range, use a hypen (-)
between the start and end interface
numbers.
E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
Step 7
switchport map protocols-group <Group id
integer(0-2147483647)> vlan <vlan-id(1-
4069)>
Associates the group to the VLAN on
the above interface.
Group id – Protocol Group Identifier
vlan-id – VLAN identifier.
Step 8
switchport pvid <vlan-id>
Configures the PVID for the default port
based VLAN behavior. This will be used
for packets that did not match any
protocol VLAN map.
The VLAN identifiers may be any VLAN
number from 1 to 4069.
The VLAN provided in this command
must exist in the switch. If the VLAN
does not exist, create it first.
Step 9
Exit
Exits the interface configuration mode.
Step 10
show vlan protocols-group
show protocol-vlan
Displays the configured protocol based
VLANs.