Supermicro SSE-F3548S - Page 102

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
102
Step 11
write startup-config
Optional step – saves this VLAN
configuration to be part of startup
configuration.
Follow the below steps to remove protocol based VLANs.
Step
Command
Description
Step 1
configure terminal
Enters the configuration mode
Step 2
interface <interface-type> <interface-id>
or
interface range <interface-type> <interface-id>
….
Enters the interface mode.
interface-type – may be any of the
following:
fx-ethernet – fx
cx-ethernet – cx
port-channel – po
interface-id is in slot/port format for all
physical interfaces. It could be a port
channel identifier for port channel
interfaces.
To configure multiple interfaces, use
the “interface range …” command. To
provide a range, use a hypen (-)
between the start and end interface
numbers.
E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
Step 3
no switchport map protocols-group <Group id
integer(0-2147483647)>
Removes the protocol groups from
interface mode.
Group id – Protocol Group Identifier
Step 4
Exit
Exits VLAN configuration mode.
Step 5
no map protocol {arp | ip | rarp | ipx | novell |
netbios | appletalk | other <
aa:aa or
aa:aa:aa:aa:aa>} {enet-v2 | RFC1042 | llcOther
| snap8021H | snapOther}
Removes the protocol group.
Before removing any protocol group, it
must have been removed from all
interfaces.
Step 6
no vlan <vlan-list>
or
vlan <vlan-list>
Removes the VLANs created for
protocol based VLANs.
If the VLAN is shared with a MAC or
port based VLAN, then remove only the