Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
The “no lacp system-priority” command resets the LACP system priority to the default value
32768.
The example below shows the steps necessary to configure the LACP system priority value.
Set the LACP system priority as 1000.
SMIS# configure terminal
SMIS(config)# lacp system-priority 1000
SMIS(config-if)# exit
4.6.4.2 LACP Port Priority
When more than eight member ports are configured, the ports that have the lowest port priority value
get selected as active member ports. If multiple ports have the same port priority value, the ports with
the numerically lower port numbers will be selected as the active member ports.
The default LACP port priority is 128.
Follow the steps below to modify the LACP port priority.
Enters the configuration mode.
interface <interface-type><interface-id>
Enters the interface mode.
interface range <interface-type><interface-id>
interface-type – may be any of the
interface-id is in slot/port format for all
To configure multiple interfaces, use
the “interface range …” command. To
To Next Page
Loading...
