Supermicro SSE-F3548S - Page 134

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
134
provide a range, use a hyphen (-)
between the start and end interface
numbers.
E.g.: int range fx 0/1-10
To provide multiple interfaces or
ranges, separate with a comma (,).
E.g.: int range fx 0/1-10, fx 0/20
Step 3
lacp port-priority <port-priority>
Configures the LACP port priority.
port-priority – may be any value from 0
to 65535
Step 4
End
Exits the configuration mode.
Step 5
show running-config
Displays the configured port priority
information.
show etherchannel
Step 6
write startup-config
Optional step – saves this port priority
configuration to be part of startup
configuration.
The “no lacp port-priority” command resets the LACP port priority to the default value of
128.
The example below shows the steps necessary to configure the port priority.