Supermicro SSE-F3548S - Page 210

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
210
SMIS(config)# int range fx 0/20-40
SMIS(config-if)#switchport mode access
SMIS(config-if)#switchport access vlan 10
SMIS(config-if)# exit
# Add member ports to VLAN 20
SMIS(config)# int range cx 0/1 fx 0/1-10
SMIS(config-if)#switchport mode trunk
SMIS(config-if)#switchporttrunk allowed vlan 20
SMIS(config-if)# exit
# Create the port channel 1 interface
SMIS(config)# int port-channel 1
SMIS(config-if)# exit
# Add member ports to the port channel 1 interface
SMIS(config)# int range cx 0/3-4
SMIS(config-if)#channel-group 1 mode active
SMIS(config-if)# exit
# Configure the VLAN requirements for the port channel 1 interface
SMIS(config)# int port-channel 1
SMIS(config-if)# switchport mode trunk
SMIS(config-if)# switchport trunk native vlan 10
SMIS(config-if)# exit
# Req.1 Enable IGMP Snooping
SMIS(config)# ip igmp snooping
SMIS(config)# vlan 10,20
SMIS(config-vlan)# ip igmp snooping
SMIS(config-vlan)# exit
# Req.2 Configure the switch as a querier for group 225.0.0.1