SYNAPTICON SOMANET Circulo 7 - Page 124

In this case, adjust the encoder ring mounting to ensure the nominal air gap.
1.2.2.3.2.3.2 The magnetic ring is too far from the encoder chip
Note the Nominal air gap for each encoder ring. If the ring is further away than specified, the following
pattern will appear in the calibration results: irregular high oscillations and isolated points (outliers) due to
high noise.
Synapticon Documentation
© 2021 Synapticon GmbH | Daimlerstraße 26 | D-71101 Schönaich Documentation v 4.19.0 | Built 2022-02-01 124/1031