[1]
[2]
[3]
[4]
[5]
[6]
[7]
The fourth phase can be used for a brake or other purposes (see Manually controlling phase D voltage) it
has a maximum current of 10 A.
Currently not supported by our standard software. Can be developed upon request, please contact
sales@synapticon.com
All Analog Inputs can be configured as single-ended 0-5 V, 0-10 V, 0-20 V or differential ±5 V, ±10 V
independently. Upon request only, please contact sales@synapticon.com
Upon Request
Two Digital IO can be configured as 5.0 V CMOS logic. Upon request only, please contact
sales@synapticon.com
Depends on the firmware used. Value given for v4.1
The actual lowest temperature is limited by the dew point. This depends on several factors, e.g. the
ambient humidity and how quick the drive cools down after operation. Special care must be taken when the
servo drive is actively cooled below ambient temperature.
To Next Page
Loading...
