SYNAPTICON SOMANET Circulo 7 - Page 476

Then it shows a sensor confguration page, where you can add, remove and configure your connected
encoders.
To configure an encoder, click onto “details” and set the parameters as you wish. If you want to use this
encoder as a motion control sensor, you will be able to test if it is properly configured in the testing area.
Synapticon Documentation
© 2021 Synapticon GmbH | Daimlerstraße 26 | D-71101 Schönaich Documentation v 4.19.0 | Built 2022-02-01 476/1031