TAJIMA TWMX-C - To Add Thread Trimming Code to the Design and Trim Thread (Data Edit Insert)

To trim thread
86
Chapter 5
2-5. To add thread trimming code to the design and trim thread (Data Edit "Insert")
This function always executes automatic thread trimming at the same position by adding thread trimming
code to the design. A stitch will be inserted before the selected stitch No. When this operation is performed
in the middle of embroidery, data set will be canceled. If the stitch with a length length is inserted, a design
will be displaced hereafter.
2-5-1. Screen
[a] Stitch No.
[b] X data (Data to move the frame in X-axis direction)
When the value is 8, the frame travel amount is 0.8 mm.
[c] Function Code(→p.243)
It is the code to indicate the role of the stitch.
[d] Y data (Data to move the frame in Y-axis direction)
When the value is 4, the frame travel amount is 0.4 mm.
2-5-2. How to operate
The following is an example that thread trimming code is added to 20th stitch.
(1) To open screen
The original design will be overwritten after editing. Back up design data according to need.
1 Data Edit
Delete
1
2
3
4
5
6
7
8
9
10
00Jump
84Stitch
83Stitch
11 5 Stitch
88Stitch
113Stitch
-11 2 Stitch
-12 -3 Stitch
-11 7 Stitch
-25 15 Stitch
Modify
Insert
[b]
[c]
[d]
[a]
CAUTION
!
1 Data Edit
6(76(7