TAJIMA TWMX-C - To Perform Frame Origin Memory When the Power Is Turned on (Frame Origin Memory with the Power-ON)

To return the frame to the original position
160
Chapter 6
3-4-2. How to operate
The following is an example of executing frame origin memory.
(1) Set to main screen.
(2) Press F2 key while pressing SET key.
(3) Press F2 key.
(4) Execute Frame Origin Memory.
3-5. To perform Frame origin memory when the power is turned ON
(Frame origin memory with the power-ON)
This function does not correspond to L-s
pec. machine. Also, it is possible to perform setting only when
"Frame limit setting" is set to "Yes".
This is the setting to display the message, and perform Frame origin memory when the power is turned ON.
When the embroidery is on the way or the main shaft is out of the fixed position, the message will not be
displayed.
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
Pressing SET key will move the frame.
CAUTION
!
6(76(7
)
1 Max. Revolution Limit
)
9 Frame Origin Memory
6(76(7
6(76(7
Frame origin memory
"YES">>SET
is executed.