To make optional device available for use
198
Chapter 8
1-6-2. How to operate
The following is an example that Boring device is set to "Step 3" and equipped to the needle bar No. "4".
(1) To open screen
(2) To select Boring step
(3) To select the needle bar No.
1-7. Bobbin changer
This is a setting for making Bobbin changer (UBC II) available for use. For details of the device, refer to the
separate manual "UBC II".
1-7-1. Explanation on the screen
1-7-2. How to operate
The following is an example of setting Bobbin changer to "To use".
(1) To open screen
YES: To use
NO: Not to use
To Next Page
Loading...