TAJIMA TWMX-C - To Reverse the 1 St Color and the 2 Nd Color in Sequin Device; (Data Conversion for Sequin Output)

Functions concerning optional device
207
Chapter 8
1
2
3
4
5
6
7
8
9
10
11
(4) To use the air compressor
3-2. To reverse the 1st color and the 2nd color in sequin device III
(Data conversion for sequin output)
This is the setting not for replacing by removing sequin but for reversing
sequin on the design data all at once when you desire to replace sequin
of the device L1 and L2 (the right figure). This function is effective only
for the step selected with sequin needle against step of sewing sequin.
3-2-1. Screen
[a] The device L1 (1st color) and L2 (2nd color) at the left side will be replaced each other.
Thus, "Sequin_O" in the design data will be replaced with "Sequin _O_2" or vice versa.
Sequin_O (Sequin output): 1st color
Sequin_O_2 (Sequin output 2): 2nd color
[b] The device R1 (1st color) and R2 (2nd color) at the Right side will be replaced each other.
YES
6(76(7
Left side
L1L2 R2R1
Right side
L1< > L2
9 Data conversion for sequin
R1< > R2
[a]
[b]