To make optional device available for use
192
Chapter 8
1-2. Automatic Lubrication System
This setting makes Automatic lubrication system available for use. For details of the device, refer to the
separate manual "Automatic lubrication system".
1-2-1. Screen
[a] Type of device
YES: Type to lubricate the inside of arm and rotary hook (LB I)
Arm: Type to lubricate to inside of the arm only (LB II)
NO: Without device
[b] Lubrication cycle to rotary hook
When counting reaches the number of set stitches, the machine will lubricate the rotary hook
(recommended value: 50000).
[c] Lubricating cycle to inside of the arm
When counting reaches the number of set stitches, the machine will lubricate to the inside of the
arm (recommended value: 150000).
-: Not to lubricate
1-2-2. How to operate
The following is an example that the lubrication cycle of the rotary hook is set to "50000" in case of type to
lubricate both the inside of arm and rotary hook.
(1) To open screen
F3
YES/Arm/NO
YES
6 Lubrication
[st]
Lubrication Cycle (Rotary hook)
100000
[st]
Lubrication Cycle (Arm)
100000
[a]
[b]
[c]
To Next Page
Loading...