TAJIMA TWMX-C - To Stop the Machine with Needle Bar Stuck in the Material (Stop at Lower D.point)

To stop the machine
95
Chapter 5
1
2
3
4
5
6
7
8
9
10
11
4-3. To stop the machine with needle bar stuck in the material (Stop at Lower D.Point)
This setting stop the machine with needle stuck in the material at the end of embroidery. This function is
effective for embroidering to consecutive design using AFC (option) mainly.
4-3-1. Screen
4-3-2. How to operate
The following is an example that Stop at Lower D. Point is set.
(1) To open screen
(2) To set Stop at Lower D. Point
YES: To set
NO: Not to set (usual setting)
10 Stop at Lower D. Point
NO
&
10 Stop at Lower D. Point
NO
YES
6(76(7