TAJIMA TWMX-C - Completion of Embroidery

Embroidery starts
75
Chapter 4
1
2
3
4
5
6
7
8
9
10
11
[Head without thread breakage (In case of 2 or more heads machine)]
The machine restarts embroidering from the position 3 next to where frame back started. This example
is for the case "Frame Back All head Sew" is set as "0".(→p.150)
To make the head without thread breakage embroider from the position where frame back is stopped,
set the tension base switch of the head to the "Top" once (when you release the switch, it will return to
the original position).
7-4. Completion of embroidery
Destination of the frame movement differs depending on setting of the machine.
Setting of Automatic Offset
Yes No
Position where Frame Back started
(position where the machine stopped)
Frame Back
Block
3
Embroidery direction
Tension base switch
Thread breakage indicator lamp will
change color from green to red.
The frame will move to the offset start position.
The frame will not move.
However, when Automatic Origin Return is set,
the frame will move to the design start position.