TAJIMA TWMX-C - To Adjust Stitching Length According to a Stitch Length (Frame Drive Adjustment)

To adjust finishing of embroidering
115
Chapter 5
1
2
3
4
5
6
7
8
9
10
11
7-8. To adjust stitching length according to a stitch length (Frame Drive Adjustment)
This function applies to 2 or more head machines.
7-8-1. Screen
[a] "Frame Type" selected now(→p.152)
The following values can be memorized at every "Frame Type".
[b] To adjust stitch in horizontal direction of around 4 mm finely
Stitch length tends to be increased in [-] value and decreased in [+] value in general due to
characteristic of the machine. However, this aptitude may not be applicable depending on
setting condition of other items and/or machine condition.
[c] Stitch in crosswise direction of around 12 mm
[d] Stitch in lengthwise direction of around 4 mm
[e] Stitch in lengthwise direction of around 12 mm
7-8-2. How to operate
The following is an example that the stitch in horizontal direction of around 4 mm is set to "+1".
(1) Set to main screen.
(2) Press F2 key while pressing SET key.
0
3 Frame Drive Adjustment
Frame Type Tubular
X 4mm
12 mm
Y 4 mm
12 mm
0
0
0
-3 +3
-3
+3
-3 +3
-3
+3
SET
F2
[a]
[b]
[c]
[d]
[e]
-3 +3
0
Increase Decrease
6(7
6(7
)
1 Max. Revolution Limit