TAJIMA TWMX-C - To Repeat at the same Place (A.S. after Auto Data Set)

To embroider the same design repeatedly
103
Chapter 5
1
2
3
4
5
6
7
8
9
10
11
6-2. To repeat at the same place (A.S. after Auto Data Set)
This setting makes the machine start automatically after finishing embroidery and embroider the same
design repeatedly.
This function is effective only when "Auto Start (AS)" is set to "YES".(→p.55)
6-2-1. Screen
6-2-2. How to operate
The following is an example that Automatic Start after Automatic Data Set is set.
(1) To open screen
(2) To set automatic start after automatic data set
YES: To set
NO: Not to set (usual setting)
After embroidery is finished, do not put your hands etc. on the table. Automatic start
operation could injure you.
6 Automatic Start after Automatic Data Set
NO
CAUTION
!
%
6 Automatic Start after Automatic Data Set
NO
YES
6(76(7