TAJIMA TWMX-C - To Set Data of the Design Automatically after the Embroidery Is Finished (Automatic Data Set after Finishing Embroidery)

To increase embroidering efficiency
120
Chapter 5
8-5. To set data of the design automatically after the embroidery is finished (Automatic Data
Set after finishing embroidery)
This function corresponds to TFMX-C, TWMX-C only.
8-5-1. Screen
[a] Perform Automatic Data Set of the design embroidered after finishing the embroidery.
YES: To perform
NO: Not to perform
[b] Delete the design automatically after finishing the embroidery.
It is selectable only when [a] is set to NO.
YES: To perform
NO: Not to perform
8-5-2. How to operate
The following is the example of "Not to perform Automatic Data Set of the design" and "Delete the design
automatically" after finishing the embroidery.
(1) Set to main screen.
(2) To press A key while pressing SET key
(3) To press A key
0
9 Automatic data set after end of embroidery
Data deletion
0
YES/NO
SET
A
[a]
[b]
YES/NO
6(76(7
$
1 Design sort (in memory)
$
9 Automatic data set after end of embroidery
6(76(7