TAJIMA TWMX-C - Design Confirmation Screen

Screen display
29
Chapter 3
1
2
3
4
5
6
7
8
9
10
11
1-5. Design confirmation screen
It is possible to check the setting content of the design to embroider from now and the occurrence record of
stop factors (Error Stack).
To switch to the design confirmation screen, press i key.
Pressing again i key will switch to the next screen.
To return to the original screen, press E key.
i key E key
(
Current position
Stitch Counter
Stitch length
Design counter
Offset
Data conversion
Rotation
Reverse
Repeat
M.Repeat
57.0
-56.8
95.2 -7.2
(From Start Point)
1/ 10
3. 10. 5. 7. 2. 7 8. 4. 1. 9.
80
10 150.0
pp
185.0
90.0
TAJIMA_W
80
0
10 -130.0
Function
Step
1 43
5
10
2
Error Stuck
14
1000 rpm
600 rpm
43210 st
280
Cap frame
2
YES
YES
NO
YES
3
4.0 mm
YES
30
+ 2
NO
4
0 st
NO
Maximum RPM
Min. Revolution
Total Stitch Counter
Frame Start Timing
Stop at Lower D.Point
Frame Back All head Sew
Frame Type
12
13
6
7
8
9
11
Upper thread detection
Under thread detection (unit)
Under thread detection (step ratio)
Auto Color Change (AC)
Auto Start (AS)
Auto Start after auto Data Set
Auto Origin Return
Jump Convert
Auto Jump
ATH
Thread trim length
Return Stitches (ATH)
Tie stitches
M.shaft Inching after ATH
70%
4
1. Design (data set design) to be embroidered from
now
2. File name
3. Design size
: Design Start Point (starting position of design)
4. Total stitch number of design
5. Current frame position
Distance from design start point
6. Current number of stitches
7. Current stitch contents
8. Number of times of embroidering this design
continuously
9. Step(→p.53)
10. Scaling up/down/reversion of design
11. Design repetition
12. Current setting contents
13. It indicates the next page exists.
Pressing key will scroll the page.
14. Stop factor occurred at last(→p.214)
Step
Offset
1/ 10
3. 10.5.7.2.7.8.4.1 9.
Automatic Offset
Current step (red)
Number of steps
Auto Color Change Offset