Embroidery starts
69
Chapter 4
1
2
3
4
5
6
7
8
9
10
11
7-1-2. Bar switch
Target model: TFMX (L)
(1) When starting the operation, move the bar switch to the right side.
(2) To stop the machine, move the bar switch to the left side.
(3) To start slow operation from the state that the machine stops, move the bar to the right side and hold it
at the position. Releasing it will change to normal operation.
7-2. Frame Back (to return the frame) / Frame Forward (to advance the frame)
Frame Back
This function will return the frame to the direction of stitches returning in the state that the needle bar is
stopped. The frame will be returned when thread breaks, and the repair stitches will be performed from
that position.
Frame Forward
This function will advance the frame to the direction of stitches proceeding in the state that the needle
bar is stopped. The frame can be moved immediately to the embroidery start point when you want to
start from the middle of embroidery.
Before starting the machine, pay enough attention to the surrounding safety. Moving
needle bar and/or frame could injure you.
Current frame position
Return the frame.
Advance the frame.
To Next Page
Loading...