Embroidery starts
74
Chapter 4
Restart the embroidery by the following procedure.
(3) Thread the needle, or change the under thread (bobbin case).
(4) Start the operation after performing Frame Back by several stitches.
Starting stitches after Frame Back differ between the head with thread breakage and the head without
thread breakage.
[Head with thread breakage]
The machine restarts embroidering from the position where Frame Back stopped (1 in the figure below).
As a result, repair stitches will be performed at the position 2 with missing stitches due to thread
breakage.
Threader (accessory)
Bobbin case
Attaching to rotary hook
Position where Frame Back started
(position where the machine stopped)
Thread broken position
Frame Back
Block
1
2
Embroidery direction
To Next Page
Loading...