Necessary works after replacing the frame
154
Chapter 6
To set the frame type to "A. clamp T" (Auto Clamp T), follow the procedure below.
To execute “Frame Origin Memory”, follow the procedure below. The frame could hit the
machine depending on the frame position and it might cause the damage of the parts.
The center of embroidery space
Upper right position
Pressing SET key will move the frame.
Frame origin memory
"YES">>SET
Code No. 5C1 will
appear.
Move the frame to the upper right
position from the center of the
embroidery space by manual
frame
travel.
Perform operation of "Frame Origin
Memory". (SET+F2)
Press E key.
Press the stop switch
immediately after moving
the frame.
(
To Next Page
Loading...