Safety Precautions
3
Chapter 1
1
2
3
4
5
6
7
8
9
10
11
Stop the machine before threading into the needle and checking the finish of embroidery.
For the machine model with the sub table, lift up and fix the sub table securely after threading and/
or adjusting the machine.
Do not damage, modify or heat the power or other cables. Do not exert undue force to them, either.
Otherwise the cables will be damaged causing fire and electric shock.
Insert the power cable plug fully. If a metallic part etc. touches an electrode in the plug, it may cause
fire and/or electric shock.
Keep away electrical units from water and chemicals. Entry or splashing of them into electrical units
leads to short circuits, causing fire, electric shock and other troubles. If water or other chemicals
enter the unit, turn OFF the power switch, shut OFF the primary power of the machine and contact
your local distributor.
Before opening the electrical boxes, be sure to turn OFF the power switch of the machine and shut
OFF the primary power. If not, it may cause electric shock.
Primary power supply
Power switch
To Next Page
Loading...