Contents
7. To adjust finishing of embroidering .................................................................................... 104
7-1. To adjust driving error of the frame (Backlash) ........................................................ 104
7-2. To adjust stitch length of satin stitch (Satin Stitch).................................................... 105
7-3. To divide a long stitch (Auto Jump)........................................................................... 107
7-4. To change stitching condition in every needle bar (Setting in units of Needle bar)... 108
7-5. To delete tiny stitch (Cleanup)................................................................................... 111
7-6. To change thread tension (Frame Start Timing) ....................................................... 113
7-7. Not to stand out the edge of upper thread (Upper thread lock timing) ...................... 114
7-8. To adjust stitching length according to a stitch length (Frame Drive Adjustment)..... 115
8. To increase embroidering efficiency................................................................................... 117
8-1. To change number of lowering needle bar at slow operation (Main Shaft Inching) .. 117
8-2. To collect up frame moving amount of consecutive jump stitches in a
batch to feed the frame all at once (Jump code combination)................................... 117
8-3. To change moving speed of needle bar case (Color change speed)....................... 118
8-4. To change travel speed of the frame (Frame Travel Speed) .................................... 119
8-5. To set data of the design automatically after the embroidery is finished
(Automatic Data Set after finishing embroidery)........................................................ 120
9. To edit design..................................................................................................................... 122
9-1. To modify the stitch (Data Edit "Modify")................................................................... 122
9-2. To insert the stitch (Data Edit "Insert") ...................................................................... 126
9-3. To delete the stitch (Data Edit "Delete").................................................................... 130
10. Setting and resetting of password ...................................................................................... 133
10-1. To change password (Functional Limit of Password)................................................ 133
10-2. To cancel the password ............................................................................................ 135
11. Functions that must be remembered.................................................................................. 136
11-1. To check the number of total stitches up to now (Total Stitch Counter).................... 136
11-2. To color in every needle bar (Needle Bar Color)....................................................... 137
11-3. To display the setting color when making the design (Needle bar information)........ 138
11-4. To check version of current software (Software Version).......................................... 139
11-5. To switch display language (Language).................................................................... 140
11-6. To release fixing of main shaft motor (weak brake) .................................................. 141
11-7. To display/Not to display the screen for reading Condition data
(Input confirmation of condition file)........................................................................... 143
To Next Page
Loading...