EasyManuals Logo

Takeuchi TL150 Workshop Manual

Takeuchi TL150
312 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #75 background imageLoading...
Page #75 background image
III-32
MACHINE CONFIGURATIONFRAME
Lift Arm Stop
WARNING
If you must work beneath the raised lift arms,
securely engage the lift arm stop. Never get
under the lift arms and bucket if they are not
sufficiently supported.
Service the lift arm stop if damaged or if
parts are missing. Using a damaged lift arm
stop or with missing parts can cause the lift
arms to drop causing injury or death.
Maintenance and service work can be done with the
lift arms lowered. If the lift arms are raised, use the
following procedures to engage and disengage an
approved lift arm stop.
Engagement
1. Park the machine on level ground and remove
the bucket.
2. Lower the lift arms to the ground and stop the
engine.
3. Remove the rear R-pin (4) from the locking pin
(1).
4. Support the lift arm stop (2) by hand and pull out
the locking pin (1).
5. Check that the spring (3) moves freely (i.e., is
disengaged from the hook (5)) and place the lift
arm stop (2) on the cylinder.
6. Sit in the seat, fasten the seat belt, start the en-
gine and lower the safety bar.
7. Raise the lift arms slowly until the lift arm stop
(2) drops onto the cylinder rod.
8. Lower the lift arms slowly until the lift arm stop
is held between the lift arm and the end of the
cylinder tube.
9. Stop the engine.
10. Install the locking pin (1) into the rear of the lift
arm stop (2) below the cylinder rod.
11. Install the R-pin (4) to the locking pin (1).
T9C409
1
2
3
4
T9C410
2
3
5
T9C411
1
2
4

Table of Contents

Other manuals for Takeuchi TL150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Takeuchi TL150 and is the answer not in the manual?

Takeuchi TL150 Specifications

General IconGeneral
Travel Speed - High11.2 mph (18 km/h)
Max Travel Speed12.4 km/h
Width1880 mm
Height2320 mm
Lift Height10.5 ft (3.2 m)

Related product manuals