e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 10
E400 Cover open jam Duplexing unit open jam P. 8-75
E430 ADU open jam: The ADU has opened
during printing.
P. 8-75
E440 Paper feed cover open jam: The paper feed
cover has opened during printing.
P. 8-76
E450 Optional LCF open jam: The optional LCF
has been disconnected from the equipment
during printing.
P. 8-76
E480 Bridge unit open jam: The bridge unit has
opened during printing.
P. 8-76
E4A0 Waste toner cover open jam (printing) P. 8-77
E4B0 Reverse path cover open jam (printing):
The reverse path cover has opened during
printing.
P. 8-77
E510 Paper transport jam
(ADU section)
ADU transport jam: The paper does not
reach the reverse path sensor after it is
switchbacked in the reverse section.
P. 8-60
E511 ADU misfeeding (Paper not reaching the
duplexing unit path entrance sensor)
P. 8-60
E540 ADU transport jam: Paper does not reach
the duplexing unit path exit sensor after it
has passed the duplexing unit path
entrance sensor.
P. 8-61
E550 Other paper jam Paper remaining jam on the transport path:
The paper is remaining on the transport
path when printing is finished.
P. 8-71
E551 Paper remaining jam on the transport path:
(when a service call occurs)
P. 8-73
E552 Paper remaining jam on the transport path:
(when the cover is closed)
P. 8-73
E570 Paper transport jam Jam not reaching the bridge unit. P. 8-62
E580 Stop jam at the bridge unit P. 8-62
E590 Jam not reaching the upper paper exit
sensor
P. 8-42
E5A0 Stop jam at the upper paper exit sensor P. 8-43
E712 RADF jam Jam not reaching the original registration
sensor: The original fed from the original
feeding tray does not reach the original
registration sensor.
P. 8-78
E714 Feed signal reception jam: The feed signal
is received even no original exists on the
original feeding tray.
P. 8-78
E721 Jam not reaching the read sensor: The
original does not reach the read sensor
after it has passed the registration sensor
(when scanning obverse side) or the
reverse sensor (when scanning reverse
side).
P. 8-79
Error code Classification Contents Troubleshooting
To Next Page
Loading...
