Viking MB 650 - Removing V-Belt; Replacing V-Belt

- Engine -
1
Removing V-belt on models with
blade clutch
- Remove clutch drum
((see section 11.07.01)
• Remove V-belt 1 from the engine
V-belt pulley and pull over the blade
bushing.
- Pull V-belt out of the housing
towards the rear.
- Pull V-belt out of the housing
towards the rear.
- Remove lower cover
(see section 05.12.01)
100 RA_6360_6375_01 - EN
Models with single speed /
three-speed drive
• Push screwdriver 1 between V-belt 2
and V-belt pulley 3.
• Actuate motorstop control bar 5, in
order to release the engine brake.
Models with Quick-Start
• Actuate motorstop control bar 5,
actuate Quick-Start lever 6 in order
to release the engine brake.
(deactivate Quick-Start beforehand,
see section 12.01.) and turn safety
key back to “Run Position”.
• Slowly pull out starter cable 4 in
order to lift the V-belt off the V-belt
pulley.
1
2
4
5
3
6
12.04 Replacing V-belt
12.04.01 Removing V-belt
Removing V-belt on models with
blade bushing
- Remove V-belt cover
(see section 05.09.01)
Models with Vario drive
- Detach V-belt at gearbox.