Viking MB 650 - Attaching Inside Left Housing Half; Replacing Housing Halves; Removing; Dismantling Inside; Right Housing Half

RA_6360_6375_01 - EN 12
- Handlebar -
02.05 Replacing housing
halves
02.05.01 Removing /
dismantling inside
right housing half
02.04.04 Attaching inside left
housing half
• Attach control bar together with left
housing half 1 in bore A on
handlebar.
Note:
Ensure that control lever is
positioned on both housing halves
on the right side.
1
A
• Attach wheel drive cable 1 in wheel
drive control bar.
1
• Tighten screws 1, 2 (1-2 Nm).
2
1
1
1
• Press wheel drive control bar 1
together to the left and insert in
bore A on the right.
22
A
1
- Install right/left cable guide
(see section 02.01.02)
Models without blade clutch /
without Quick-Start
- Remove bracket
(see section 03.08.01)
Models with blade clutch
- Remove throttle lever
(see section 03.09.01)
MB 650.0 TK, MB 655.0 GK
- Remove throttle lever
(see section 03.09.01)
MB 650.0 T
- Remove inside right housing half
(see section 02.03.01)
MB 650.0 T
- Attach inside right housing half
(see section 02.04.02)
02.05.02 Attaching / assembling
inside right housing
half
Models without blade clutch /
without Quick-Start
- Install bracket
(see section 03.08.02)
Models with blade clutch
- Install throttle lever
(see section 03.09.02)
MB 650.0 TK, MB 655.0 GK
- Install throttle lever
(see section 03.09.02)