Viking MB 650 - Housing; Replacing Housing; Replacing Housing Cover Assembly

RA_6360_6375_01 - EN
MB 650.0 T/ V/ VE/ VM,
MB 655.0 V/ VM/ G/ GM,
MB 655.1 V/ VM/ G
• Detach motorstop cable 1 at engine
using long-nose pliers 2.
- Housing -
05.01 Replacing housing
05.01.01 Removing housing
- Remove engine
(see section 12.05.01)
05.02 Replacing housing
cover assembly
05.02.01 Removing housing
cover assembly
- Remove damper set
(see section 12.06.01)
- Remove front axle
(see section 04.01.01)
- Remove rear axle (with gearbox)
(see section 04.02.01)
- Remove translatory lever
(see section 07.03.01)
- Remove left console
(see section 08.03.01)
- Remove right console
(see section 08.03.03)
- Remove guiding plate
(see section 05.11.01)
- Remove right/left protection
bumpers
(see section 05.10.01)
05.01.02 Installing housing
- Install guiding plate
(see section 05.11.02)
- Install right/left protection bumpers
(see section 05.10.02)
- Install right console
(see section 08.03.04)
- Install left console
(see section 08.03.02)
- Install rear axle (with gearbox)
(see section 04.02.04)
- Install damper set
(see section 12.05.02)
- Install engine
(see section 12.06.02)
- Install front axle
(see section 04.01.04)
- Install translatory lever
(see section 07.03.02)
05. Housing
Note:
Set the cutting height adjustment to
the highest position (position 7).
55