Viking MB 650 - Replacing Rear Axle; Removing Rear Axle (with Gearbox)

RA_6360_6375_01 - EN37
- Chassis -
• Fit retaining washer 1 to pin and clip
in using long-nose pliers.
1
- Install front wheel
(see section 04.04.03)
- Install translatory lever cover
(see section 05.07.04)
04.02 Replacing rear axle
04.02.01 Removing rear axle
(with gearbox)
- Remove rear wheel cover
(see section 04.06.01)
- Remove height adjustment spring
(see section 07.01.01)
• Remove retaining ring 1 using long-
nose pliers.
1
Models MB 650.0
up to serial number 4 31 244 751
Models MB 655.0
up to serial number 4 31 230 687
• Attach translatory lever 1 to axle 2
(swivel plate).
1
2
 04.01.04 (A)
• Fit washer 1 to pin of axle 2. Attach
translatory lever 3 in direction of
arrow. Tighten nut 4 (4-6 Nm).
1
3
2
4
Models MB 650.0
from serial number 4 31 244 752
Models MB 655.0
from serial number 4 31 230 688
 04.01.04 (A)
04.01.04 (A)
Models MB 655.1