- Blade clutch -
- Install blade mounting
(see section 11.01.04)
- Remove blade mounting
(see section 11.01.01)
- Push the V-belt forwards towards
the engine and detach from the
engine V-belt pulley.
11.06.02 Installing blade
mounting ball bearing
11.07 Replacing clutch drum
11.07.01 Removing clutch drum
• Fit ball bearing 1 (2 pcs) and press
in using a suitable tool (press tool,
tube etc.).
• Tighten screws 2 (4-5 Nm).
VIKING special service tool
0000 890 6500
(for removing clutch drum)
consisting of puller ring 1,
four screws 3 and bolt 4.
• Push puller ring 1 onto clutch bell
shaft 2 and tighten all four screws 3
evenly (10 Nm).
• Screw in bolt 4 by approx. 1/3.
Note:
Always replace both ball bearings.
- Remove V-belt cover
(see section 05.09.01)
Models with Vario drive
- Detach V-belt at gearbox.
Models with three-speed drive
• Push screwdriver 1 between V-belt 2
and V-belt pulley 3.
• Slowly pull out starter cable 4 in
order to lift the V-belt off the V-belt
pulley.
Warning:
Position puller ring 1 on clutch bell
hub 2 so that the four screws 3 align
with the four bridges in the hub
(otherwise there is a danger of
crushing the hub).
90 RA_6360_6375_01 - EN
To Next Page
