Viking MB 650 - Blade Clutch; Quick-Start Lever; Removing Blade Clutch; Quick-Start Lever; Dismantling Blade Clutch; Quick-Start Lever

RA_6360_6375_01 - EN27
- Control bars and levers -
03.04 Replacing blade
clutch / Quick-Start
lever
03.04.01 Removing blade
clutch / Quick-Start
lever
• Detach motorstop / Quick-Start
control bar 1 from handlebar on
right.
- Remove outside right housing half
(see section 02.03.02)
1
• Remove nut 1 and pull out bolt 2.
Remove blade clutch / Quick-Start
lever 3 with washer 4 and bushing 5.
1
4
2
3
5
03.04.02 Dismantling blade
clutch / Quick-Start
lever
• Detach cable 1 from blade
clutch / Quick-Start lever 2.
1
2
• Detach detent lever 1 from blade
clutch / Quick-Start lever 2.
• Remove 1 screw,
re move reinforcement 2.
Detach detent lever 3 from blade
clutch / Quick-Start lever 4.
1
2
from serial number 4 31 076 057
up to serial number 4 31 076 056