Viking MB 650 - Installing Vario;Three-Speed Lever

RA_6360_6375_01 - EN31
- Control bars and levers -
• Insert lever 1 in housing.
1
• Tighten screw 1 with washer 2
(4-5 Nm).
2
1
03.07.02 Installing Vario /
three-speed lever
• Remove lever 1 from housing half
(the spring washers must not be
removed).
1
• Check correct position of spring
washers 1 (opposing position).
1
1
Illustrations show version with
blade clutch - (additional
throttle lever)
• Detach cable 1 from lever 2.
1
2
2
1
• Remove screw 1 with washer 2.
1
2