Viking MB 650 - Removing Right Centre Handlebar Section; Installing Right Centre Handlebar Section

RA_6360_6375_01 - EN17
- Handlebar -
02.09.03 Removing right centre
handlebar section
• Detach motorstop control bar 1 /
blade stop control bar 1 on right of
centre handlebar section.
Models with blade clutch / with
Quick-Start
- Remove blade clutch / Quick-Start
lever
(see section 03.04.01)
1
• Remove nut 1.
1
• Remove right centre handlebar
section 1.
1
- Remove outside right housing half
(see section 02.03.02)
- Remove starter cable guide
(see section 02.08.01)
- Remove cable anti-kink protection
(see section 02.07.01)
- Install cable anti-kink protection
(see section 02.07.02)
02.09.04 Installing right centre
handlebar section
• Attach right centre handlebar
section 1.
1
1
• Tighten nut 1 (8-10 Nm).