Viking MB 650 - Replacing Ignition Lock; Removing Ignition Lock; Installing Ignition Lock

RA_6360_6375_01 - EN23
- Handlebar -
1
3
2
• Remove nut 1 and remove ignition
lock 2 together with toothed disk 3
from housing half.
• Detach connection cables 1, 2.
1 2
1
2
02.13.02 Installing ignition lock
1
2
3
• Insert ignition lock 1 together with
toothed disk 2 from inside through
opening in housing half.
• Tighten nut 3 (with convex side
facing outwards) (hand-tight,
1-2 Nm).
- Attach inside left housing
half (see section 02.04.03)
- Connect battery
(see section 13.01.02)
1
2
1
2
• Attach connection cables 1, 2
(polarity is indifferent).
02.13 Replacing ignition lock
02.13.01 Removing ignition lock
- Disconnect battery
(see section 13.01.01)
- Remove inside left housing half
(see section 02.03.03)