- Chassis -
04.10 Replacing carrying
handle
04.10.01 Removing carrying
handle
04.10.02 Installing carrying
handle
- Remove front axle
(see section 04.01.01)
- Dismantle front axle
(see section 04.01.02)
- Assemble front axle
(see section 04.01.03)
- Install front axle
(see section 04.01.04)
54 RA_6360_6375_01 - EN
04.09 Replacing drive shaft
bearing
04.09.01 Removing drive shaft
bearing
- Remove rear axle (with gearbox)
(see section 04.02.01)
- Dismantle rear axle
(see section 04.02.02)
04.09.02 Installing drive shaft
bearing
- Install rear axle (with gearbox)
(see section 04.02.04)
- Assemble rear axle
(see section 04.02.03)
• Fit shim ring 1.
- Install left drive pinion
(see section 04.07.04)
- Install right freewheel wedge
(see section 04.08.03)
Models with single-speed / Vario
gearbox
- Install single-speed / Vario gearbox
support
(see section 06.04.02)
Models with three-speed gearbox
- Install three-speed gearbox support
(see section 06.04.04)
• Clip in right axle bracket 1.
• Insert freewheel wedge 1 (left side)
and push gearbox 2 to the right up
to stop.
04.08.04 Installing left freewheel
wedge
- Remove right drive pinion
(see section 04.07.03)
Note:
Ensure correct installation position
of freewheel wedge 1 (see Fig.).
To Next Page
