Viking MB 650 - Replacing Upper Handlebar; Removing Upper Handlebar; Attaching Upper Handlebar; Replacing Cable Anti-Kink Protection

RA_6360_6375_01 - EN 14
- Handlebar -
1
2
3
3
2
02.06 Replacing upper
handlebar
02.06.01 Removing upper
handlebar
- Remove outside left housing half
(see section 02.03.04)
• Remove nuts 1 and pull out bolts 2.
• Remove handlebar 3.
- Remove outside right housing half
(see section 02.03.02)
2
1
1
2
3
02.07 Replacing cable
anti-kink protection
02.07.01 Removing cable
anti-kink protection
• Detach cables 1.
1
• Remove rotary handles 1.
• Remove cable anti kink protection 2/
bolt 3 from centre handlebar
section.
Note:
Only one cable anti-kink protection
2 is required on the MB 650.0 T.
A bolt 3 is installed in place of the
second cable guide.
1
1
2
2
3
02.06.02 Attaching upper
handlebar
- Attach outside right housing half
(see section 02.04.01)
• Attach handlebar 1.
• Insert bolts 2 through handlebar
tube and tighten nuts 3 (8-10 Nm).
- Attach outside left housing half
(see section 02.04.04)