Viking MB 650 - Installing Detent Lever; Removing Detent Lever; Removing Locking Lever; Replacing Detent Lever

RA_6360_6375_01 - EN29
- Control bars and levers -
03.06 Replacing locking lever
03.06.01 Removing locking lever
• Detach motorstop / Quick-Start
control bar 1 from handlebar on
right.
- Remove inside right housing half
(see section 02.03.01)
1
• Remove detent lever 1 from control
bar 2.
12
03.05 Replacing detent lever
03.05.01 Removing detent lever
- Dismantle blade clutch / Quick-Start
lever
(see section 03.04.02)
- Remove blade clutch / Quick-Start
lever
(see section 03.04.01)
03.05.02 Installing detent lever
- Assemble blade clutch / Quick-Start
lever
(see section 03.04.03)
- Install blade clutch / Quick-Start
lever
(see section 03.04.04)
- Attach outside right housing half
(see section 02.04.01)
1
1
A
• Insert motorstop / Quick-Start
control bar 1 into guide A on
handlebar on right.
• Engage locking lever 1 in detent
lever 2.