Viking MB 650 - Replacing Blade Stop; Quick-Start Control Bar

RA_6360_6375_01 - EN25
- Control bars and levers -
03.02.02 Installing motorstop
control bar
• Press control bar 1 together and
insert in recesses A in handlebar.
- Attach inside right housing half
(see section 02.04.02)
- Attach inside left housing half
(see section 02.04.03)
1
A
1
A
1
• Attach motorstop cable 1 to control
bar 2.
1
2
• Fit motorstop cable 1 in cable
support 2 and insert cable support
into outside left housing half.
2
1
03.03 Replacing blade
stop / Quick-Start
control bar
03.03.01 Removing blade
stop / Quick-Start
control bar
- Remove inside right housing half
(see section 02.03.01)
• Press motorstop / Quick-Start
control bar 1 together at both sides
and detach from handlebar.
- Remove inside left housing half
(see section 02.03.03)
1