Viking MB 650 - Installing Single-Speed V-Belt Pulley; Removing Vario V-Belt Pulley and Adjusting Element

- Gearbox -
- Install V-belt cover
(see section 05.09.02)
06.02.03 Removing Vario V-belt
pulley and adjusting
element
- Remove V-belt cover
(see section 05.09.01)
- Detach V-belt.
• Detach speed control cable 1 from
gearbox.
• Drive in roll pin 1.
• Fit V-belt 1 onto V-belt pulley 2.
• Actuate motorstop control bar 4, in
order to release the engine brake.
• Slowly pull out starter cable 3 in
order to attach the V-belt to the
V-belt pulley.
1
2
3
4
06.02.02 Installing single-speed
V-belt pulley
• Attach V-belt pulley 1 to gearbox 2.
66 RA_6360_6375_01 - EN