- Gearbox -
06.02.05 Removing three-speed
V-belt pulley
06.02.06 Installing three-speed
V-belt pulley
- Remove V-belt cover
(see section 05.09.01)
• Remove retaining ring 1 and remove
V-belt pulley 2 from gearbox 3.
• Fit V-belt pulley 1 onto gearbox 2,
install retaining ring 3.
- Install V-belt cover
(see section 05.09.02)
- Attach the V-belt.
• Insert Vario drive cable 1 in bore A
and then attach to support B.
• Push screwdriver 1 between V-belt 2
and V-belt pulley 3.
Models without blade clutch /
without Quick-Start
• Actuate motorstop control bar 5, in
order to release the engine brake.
Models with Quick-Start
• Actuate motorstop control bar 5,
actuate Quick-Start lever 6 in order
to release the engine brake.
(deactivate Quick-Start beforehand,
see section 12.01.)
• Slowly pull out starter cable 4 in
order to lift the V-belt off the V-belt
pulley.
To Next Page
