RA_6360_6375_01 - EN43
04.02.04 Installing rear axle
(with gearbox)
• Insert axle 1 (with gearbox) into
housing.
- Chassis -
Note:
Ensure correct installation position of freewheel wedge 1 (see Fig.).
• Insert freewheel wedge 1 into shaft 2 through bore A (right side).
• Fit pinion 1 (Part No. 6105 704 7400).
• Fit washer 2.
• Fir retaining ring 3 on shaft 4.
To Next Page
