Xerox 4112 User Manual

Problem Solving
12-6 Xerox 4112/4127 Copier/Printer
User Guide
Documents are
not fed into the
document feeder.
Are the documents too small? The minimum size of the document that can be
loaded on the document feeder is A5 and 5.5 X
8.5.in.
Refer to Loading Paper into Trays on page 8-1.
An error message
is displayed after
paper is loaded in
paper Tray 5
(Bypass) and the
Start button is
pressed.
Check the position of the
paper guides at the front side
of paper Tray 5 (Bypass).
Set the paper guides to the correct positions.
Refer to Loading Paper into Tray 5 (Bypass) on
page 8-5.
Documents jam
often.
Is the right type of paper/
media being used?
Make sure the document feeder is loaded properly
with acceptable media.
Refer to Loading Documents on page 2-1.
Are you trying to copy irregular
shaped documents, business
cards, transparencies, or thin
documents?
Are you trying to copy
documents affixed with sticky
labels, paper clips or adhesive
tape?
Remove sticky labels, paper clips or adhesive tape
from the document before copying.
Are the document guides at
the correct position?
Properly set the document guides.
Refer to Loading Documents on page 2-1.
Is part of the document
ripped, and a piece of paper
remaining in the document
feeder?
Open the document feeder cover and check for
pieces of paper.
Refer to Document jams on page 12-73.
When importing originals of
different sizes, is the
Mixed Size Originals setting
set to ON?
Set Mixed Size Originals to ON.
Refer to Mixed Size Originals on page 2-27.
Is an A5-size document loaded
horizontally ( ) on the
document feeder when the
Mixed Size Originals feature is
in use?
Load the A5-size document vertically ( ).
A corner of the
document is
folded.
Is the document curled? Flatten out the curl and load the document again.
Stapler faults – Refer to Stapler Faults on page 12-76.
Symptoms Check Remedy

Xerox 4112 Specifications

General

Brand	Xerox
Model	4112
Category	All in One Printer
Language	English