Product Demonstration
CAUTION
SO Hz machines only:. Do not run program 3-
60-3 as this will cause all settings on the Printer
to be lost.
To demonstrate the capabilities of the Printer,
refer to the User Guide. Perform the following
procedures to train an operator.
a. Getting to know your Printer
b. Control Console
c. Loading the media
d. Making prints using roll media
e. Adding Toner and how to clear the J1
Status Code
f. Problem solving status codes
g. Clearing the Printer
Installation Checklist
Site Preparation
a. Supply voltage check
b. Space requirements
Installation
a. Remove the packing material
b. Remove the Toner Cartridge
c. Adding Developer Material
d. Install the Toner Cartridge
e. Level the Printer
f. EO Only: Set the 220/240 switch
g. Enable the correct language
Functional Check
CAUTION
When starting to operate the Printer, do not run
9-21-S. The Developer Material in this machine
has already been initialized. There is no need to
run this program again.
a. Switch on the Printer and allow the
Printer to warm up.
b. Set the Country Configuration (ADJ 3.2).
c. Initialize the Web Oiler [1030].
d. Set the Vertical Magnification (ADJ 8.1).
e. Set the Lead Edge Registration (ADJ
8.2).
f. Set the Cut Length (ADJ 8.3).
g. Perform the Electrostatic Series (ADJ
9.2).
h. Make three test prints using [9-55-5] and
[9-55-7].
i. Check the print quality using Section 3 of
this Service Manual,
j. Check the operator adjustments.
Product Demonstration Checklist
a. ON/OFF switch, Print Count Meter, and
serial number plate
b. Control Console
c. Replacing the Toner Cartridge
d. Problem solving status codes
e. Clearing the Printer
8830
1/98
6-25
Installation
To Next Page
Loading...
Need help?
General
