To Next Page

To Previous Page

REFERENCE SYMBOLOGY

Notes, adjustments, and parts lists, support the checklists and the RAP information. The sym-

bols that refer to this supportive date are shown below, component control

Note

The code [0403] is an example of an output diagnostic test.

This symbol is used to refer to notes usually found on the same page.

Adjustments

Voltage Source

This is an Indication of the source voltage that is used for operation of a component.

This voltage is distributed in the PWB and comes from the LVPS.

Switch/relay contacts with momentary contacts shown normally open.

Switch/relay contacts with momentary contacts shown normally closed.

Statue Code

Flag

This symbol Indicates an area of a Circuit Diagram that you should check.

Reference to a Repair Procedure - This symbol indicates that the part has a Repair

procedure listed in the Repair / Adjustment section of this manual.

Reference to an Adjustment Procedure • This symbol indicates that the part has an

Adjustment procedure listed in the Repair / Adjustment section of this manual.

Reference to an Adjustment and Repair Procedure - This symbol indicates that

the part has an Adjustment procedure and a Repair procedure listed in Section 4.

8830 DDS

3/98

introduction

Reference Symbology

Switches and Relay Contacts

Safety Interlock switch that is open.

Safety Interlock switch that is closed.

Parts List

The status coda is represented by a box in the control logic section of the circuit

diagram.

Pl 1.1

Reference to an Exploded Drawing • The spared component is found in the partic-

ular drawing in the Parts List.

Xerox 8830 Service Manual

Other manuals for Xerox 8830