Introduction 3/98
Reference Symbology XII 8830 DDS
This symbol indicates an interrupted signal in a horizontal direction.
A Driver that is used to switch on DC components
Relay or Clutch Solenoid.
Solenoid
This symbol Indicates a machine ground.
Ground
Other Symbols
WARNING
A warning is used to alert the personnel to an operating or maintenance procedure,
practice, or condition that, if not strictly observed could result in injury or loss of life.
Plug /Jack Connector and pin number.
Connector
Motor
Motor
A caution is used to alert the personnel to an operating or maintenance procedure,
practice, or condition that, if not strictly observed, could result in damage to, or destruc-
tion of equipment
CAUTION
CAUTION
This symbol is used when components in the copier are susceptible to
damage from electrostatic discharge. Observe ESD procedures to avoid
component damage.
Driver
Thermistor
Thermistor Bead, used to sense temperature
To Next Page
Loading...
